Abstract
A breath-alcohol interlock is installed at an entrance door of a dwelling. A test unit is mounted on the outside of the door,
on the inside, or on both sides. The interlock controls only the ingress side of the door: an electrically controlled strike,
lock, or latch release on the outside lever or trim is released when an identified, monitored person provides a valid breath
sample below a configured threshold. Withholding ingress until that test is passed is also a household-safety measure: it
keeps an intoxicated monitored person out of the dwelling and so protects children and other occupants, including a partner
of any gender, such as a boyfriend or a girlfriend. The egress side is never placed under the interlock's control. The inside
lever, knob, or thumb-turn always opens the door with one ordinary motion, without a key, credential, test, or special
knowledge. When that mechanical latch is used, a sensor on the inside lever or bolt detects the actuation and the controller
immediately notifies the supervising parole or probation officer, or the monitoring agency, of the egress event. That
notification is the primary response to an inside exit; it does not delay or block the door. If the primary network or power is
down, the event is stored in a battery-backed, hash-chained log and sent by a cellular or wired fallback, or forwarded when
a path returns. The controller distinguishes egress from re-entry, and may request an optional breath sample after the exit.
The system may also be installed with wireless opening sensors on windows and on other exits, such as a patio, basement
or garage door. Each sensor has an opening switch and a motion, gyroscope or accelerometer element, so that a normal
opening can be distinguished from tampering, including prying, removal, magnet defeat or the sensor being knocked off.
An opening or a tamper event is reported to the supervising officer or agency in the same way as an inside-latch egress
alert. Those windows and other exits are never locked or blocked. A low or dead battery on any sensor or on the controller,
a loss or restoration of mains power, and a missed radio check-in from a sensor are themselves reported. A fire-alarm or
smoke-alarm signal, a loss of power, or a fault places the ingress side in a configured state, normally released for entry, and
logs the event. On a confirmed failed test the ingress side stays locked to the monitored person, and the supervising officer
or agency is sent an immediate alert with the reading, the time and a photograph from the test window. The door unit may
open a two-way voice or video call with the officer, who may order a retest, dispatch a responder, or remotely authorize
entry. An optional tie-in with an existing ankle or GPS location monitor lets the officer see where the person goes; leaving
the door or the premises after a failed test is logged as its own event. The arrangement does not apply any physical
restraint; it only denies entry and reports. The challenge is person-selective. Only the monitored person is asked to test;
other household members and visitors enter with their ordinary keys, codes, phones, or fobs. Other household members
may also opt in to a smaller non-breath terminal on another door, operated by a credential, phone or fob of their own, so
that they can come and go through that door. The terminal is installed only with that occupant's consent. If the monitored
person's existing ankle or location monitor is in proximity of that door, determined by short-range radio ranging or a
radio-frequency beacon, the door's outside trim is not released for anyone. If the door is nevertheless opened while the
monitor is nearby, including from the outside, or is held or propped open, the system alerts or opens a call to the officer.
Inside egress on every such door remains mechanical and is never blocked; the proximity rule gates only outside
unlocking. The monitored person is identified, and the identity is bound to the breath sample in the same test window, by
one or more of the following: a camera face match during the blow, a phone credential, a radio-frequency identification
fob, or an implanted near-field secure-element chip that answers a cryptographic challenge from a reader placed beside the
mouthpiece while the breath is being delivered. The implant may be required as a condition of court-ordered release or
supervision; otherwise it is optional, and the camera, phone and fob paths remain available. Breath validity checks shared
with the vehicle-interlock and remote-breath-testing art are cross-referenced: top-and-bottom lip-contact capacitance, a
carbon-dioxide band over the blow, humidity and temperature, and camera verification of the blow. The disclosure also
covers retest windows, failed-test escalation to the supervising officer, opt-in non-breath terminals on other doors with
proximity gating, reporting to a monitoring service, tamper detection, offline operation with a signed local log, radio
supervision of perimeter sensors, and on-device processing so that no image or biometric template leaves the door unit by
default. An illustrative site-energy figure at the meter is given; it is an arithmetic example, not a measurement.
Creative Commons License

This work is licensed under a Creative Commons Attribution-Share Alike 4.0 License.
Recommended Citation
Boll, Joe, "Home Door Sobriety Interlock with Ingress-Only Gating, Free Egress, and Identity-Bound Breath Testing", Technical Disclosure Commons, ()
https://www.tdcommons.org/dpubs_series/13157